How To Repair A 3 Way Lamp Socket

If you have a lamp with a loose socket that causes the lamp to flicker, to exist difficult to turn on, or to just flat out refuse to light, yous tin supersede the socket and give the lamp a new life. You can supervene upon a socket so easily that, even if information technology'southward not your favorite lamp, you may desire to fix it and give it to someone else, similar your nosy neighbor.

You can buy replacement lamp parts at any hardware store or home center. These parts are standard; you can buy lamp cord by the foot, and you lot can utilise just about whatsoever blazon of plug to replace the 1 on your old lamp.

Y'all can detect several varieties of lamp socket switches. You command some by pushing a short shaft on the side of the switch, others by turning a knob, and yet others with a pull chain. You likewise need to consider whether your present lamp has a three-way bulb in it. If you could turn the lamp on to several degrees of brightness, be certain to purchase a socket switch that'southward designed to command a iii-style bulb.

You lot can probably get the correct replacement parts near easily past taking the lamp apart (according to the following directions) and bringing the bad parts to the store and then that you can observe matching replacements.

To replace a lamp socket, follow these steps:

1. Unplug the lamp.

2. Remove the shade, bulb, and harp (the wired shape that holds the shade).

3. Snap off the socket trounce from the socket beat cap.

   

   Nigh sockets have the word Press stamped in two places on the shell. Squeeze the shell at those points and pull upwardly to remove it. If the shell doesn't budge, button the end of a screwdriver between the base of the socket and the side of the shell then pull the shell up and off the socket base of operations.

4. Pull the socket switch upward out of the beat out base to expose enough of the switch to reveal the 2 wires attached to information technology.

   If the screws are loose, tighten them and reassemble the lamp. Loose screws may have been the lamp's only problem. If the lamp works after you tighten up the screws, great! If not, take it apart again and proceed with the post-obit steps.

5. Unscrew the wires.

   A lamp switch has a contumely spiral to which the hot (black) wire is fastened and a silver screw to which the neutral (white) wire is attached. Lamp cords, however, don't have colored wires in them. So, before you remove the wires from the old switch, note which color screw each wire is connected to.

6. Loosen the socket cap prepare screw so unscrew and discard it along with the erstwhile socket crush and socket.

7. Screw the wire leads to the new socket.

8. Place the new socket vanquish over the socket and push the cover down until information technology snaps into the new socket shell cap.

9. Supercede the harp, light bulb, and shade.

About This Article

This commodity can exist found in the category:

• Electrical ,

How To Repair A 3 Way Lamp Socket,

Source: https://www.dummies.com/article/home-auto-hobbies/home-improvement-appliances/electrical/how-to-repair-a-faulty-lamp-185375

Posted by: krakertheiven.blogspot.com

Share this post